String to hang (you may like to attach a dowel or ruler to the back to keep the top section flat)
9 Rings or additional String
Velcro Dots (at least 25 soft sides and 13 rough sides)
First you'll need to print out the PDF and cut out all the bits. (Note, on page 2 you'll need to cut all the small colourful weather labels and on page 3 there are three arrows and a section for 'Breeze'. Cut the arrows individually but leave the Breeze section in a long rectangle.)
Once you've got all the pieces cut you'll need add an extra blank sheet of paper to the bottom as a type of 'storage' section for the weather labels.
Next, work out how to put all of your bits into the laminating sheets efficiently and send it all through the laminator.
You'll then need to cut all your small pieces again.
Use the hole punch to punch holes where strings/rings need to go (like in the picture)
String it all together.
Add the velcro dots everywhere. You'll need soft side dots in all the sections you can see in the picture and you'll need to make sure you've got 10 additional soft dots on the blank sheet at the bottom for storage. Use the rough side dots for the backs of each of the small labels and arrows. I use the rough sides for these and not the actual pages as if you end up walking to close to the banner, the rough sides can scratch so I only use the rough ones on the backs of the labels.